Combine Moisture Sensor Checks

Before field work

• Write the equipment make, model, model year, firmware, harness type and installed display for your farm.
• Describe the soil moisture and field sensors job scope and require a written equipment compatibility review.
• Ask the installer to distinguish hardware, activation licenses, correction subscriptions, and labor charges.
• Request a field test of power, mounting, signal, data transfer, calibration and manual override.
• Confirm written warranty, response windows, service travel rates and operator handover.

A useful field verification procedure

• Define the expected outcome for combine moisture sensor checks and the field or machine where it applies.
• Record a baseline or existing system measurement, including machine setup and operating conditions.
• Test the revised installation using a repeatable route, pass, job or sensor reading.
• Capture any error messages and save the display or device settings with the date.
• Compare observed performance with the acceptance criteria agreed with the installer.

Recordbook fields for 4-H and FFA

• Project purpose and supervisor
• Equipment and safety checks
• Date, measured values and photographs (with appropriate permission)
• Cost, labor hours and lessons learned
• Follow-up maintenance and recalibration

Related installation topics

Official references

Use these resources to verify applicable regulations and technical requirements:

• USDA precision agriculture
• NRCS conservation practice resources
• FAA drone operations
• National FFA Organization